| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-15-2005, 04:19 PM
| |||
| |||
I have Gecko 320's and am using them with Mach2 on servos. I am confused, the information with the Geckos says you don't need a seperate 5vdc power supply for the encoders on the servos hooked to the Geckos, then later it tells you to hook up a 5vdc supply to the last pin. My encoders should fall under the 50mA encoder limit. What am I missing? Which is it, do I need to hook up a seperate 5vdc to the last pin or ignore it? I really don't want to let the magic smoke out of them. Thanks for the help. Ron  |
|
#2
02-18-2005, 01:07 PM
| |||
| |||
| Never Mind, I figured it out. Thanks |
|
#3
01-26-2010, 05:53 PM
| |||
| |||
| coudl you please let me know what did you do? im trying to use the same driver and mach3...regards MARCOS |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hooking up HobbyCNC board and motors to PC... | jdbaker | Hobbycnc (Products) | 7 | 06-06-2005 01:10 PM |
| Hooking it all up | Dylwad | DeskCNC Controller Board | 6 | 05-02-2005 12:38 AM |
| My geckos have a mind of their own | bgolash | General Electronics Discussion | 1 | 04-30-2005 12:08 PM |
| Gecko's faulting | dowling177 | Gecko Drives | 2 | 04-08-2005 02:02 PM |
| Turbo CNC and geckos | snoman70 | TurboCNC | 9 | 03-30-2005 06:47 AM |
| | |
Linear Mode
