| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-27-2009, 10:46 PM
| |||
| |||
I am having trouble getting my Gecko 320's and US Digital E5 encoders working togther. When I first turn on the drives the fault lights are on and after a few seconds they turn off and the drives start cycling. The motors will turn for a few seconds then stop and then restart. After a few cycles the fault lights will light again and the entire process starts over. If I unplug the encoders the motors will run at top speed with no problems. I am new to this and am really not sure what to do next? Any ideas?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Digital Version of Digital Machinist | castiron43 | Village Press / Digital Machinist | 31 | 04-12-2011 03:42 AM |
| Help with EMC and Gecko320 | BWay | LinuxCNC (formerly EMC2) | 9 | 07-08-2009 05:39 AM |
| US Digital E2 encoder & Rutex 2010, somethings not right... | Splint | Servo Drives | 1 | 11-30-2007 07:20 PM |
| Encoder for digital readout on bender? | Pook | General Electronics Discussion | 3 | 05-15-2007 05:20 AM |
| 80.8 volts to a 80 volt gecko320? | balsaman | Gecko Drives | 4 | 07-05-2003 12:17 PM |
| | |
Linear Mode
