| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-12-2009, 09:23 AM
| |||
| |||
Re:Gecko 203V mach 3 settings. Hi Mariss, On the motor tuning page there is "Step Pulse 1 - 5us" and "Dir Pulse 0 -5". So step pulse should be set to "2" but what about dir pulse? thanks, Brendin  |
|
#2
05-12-2009, 11:27 AM
| |||
| |||
| Leave the "Direction precharge time" at '0' microseconds. Mariss |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C11G, Gecko 203v and Mach 3...connect what where? | teamtexas | Gecko Drives | 16 | 12-03-2009 09:53 PM |
| Need Help!- Eliminating the automatic "G91" in Mach 3 Post Processor | m1911bldr | BobCad-Cam | 1 | 01-14-2009 01:40 PM |
| "Mach Convention", (South East)...any interest???? | PoppaBear10 | Trade Shows and Events | 112 | 03-26-2008 07:44 PM |
| Calculating "steps per" in Mach3 with Gecko 203V | millman52 | Machines running Mach Software | 7 | 11-28-2007 03:04 PM |
| Can Mach-like software run "hobby servo"? | dondeaida | RC Robotics & Autonomous Robots | 10 | 07-23-2007 09:55 AM |
| | |
Linear Mode
