Newbie Gecko G201 Max inductance - CNCzone.com-The Largest Machinist Community on the net!

VooDooMan · #1 04-30-2009, 08:07 PM

Hello all,

Searched for a bit but I was not able to find any thing.

I am curious what is the G201 able to handle in terms of inductance, 15-20 mH?

Thanks all
Christian

VooDooMan · #2 05-01-2009, 09:19 PM

any body?!

Richards · #3 05-06-2009, 07:26 PM

Here is a quote from page 1 of the G201 manual found at www.geckodrive.com:

"Motor winding inductance should be 500uH or greater, but generally no more than 5.5mH."

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
G201 w/ 48VDC/10A P/S... Will 10A fry the Gecko?	ngr1	Gecko Drives	11	11-10-2009 10:03 PM
motor inductance?	fido	Stepper Motors and Drives	0	01-15-2009 11:24 AM
Adding Inductance	fanucster	Servo Motors and Drives	0	07-17-2007 08:58 PM
Gecko G201 & Mach3	szynszyl	Gecko Drives	0	04-10-2007 05:11 PM
calculating inductance	2muchstuff	General Electronics Discussion	2	11-13-2005 12:27 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)