Estopping Mach and other drives with fault condition - CNCzone.com-The Largest Machinist Community on the net!

jubee · #1 04-23-2009, 05:50 AM

Hi to all out there................................out there...

Is there a electronics diagram out there / here on the zone for a reset/err estop/Mach .... for the gecko 320.

All Iam after is that Mach registers a fault with geckos,so the program stops,
and the other drives stop also.

Any help or thoughts would be good.....Thanks?

Regards
JUbee

Runner4404spd · #2 04-23-2009, 02:35 PM

i think this needs to be wired to the e-stop switch as well. ultimately though i am looking for the same info as the OP.

thanks

Al_The_Man · #3 04-23-2009, 03:03 PM

Did you check this out?
http://www.sfu.ca/~alan/gecko/err.html
Little bit cumbersome to have to go to this, but it may be an answer.
Al.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
conversion of anilam drives with mach 3 software	ptpz	Machines running Mach Software	11	03-15-2011 01:48 PM
201 drives fault over and over	wes	Gecko Drives	4	07-03-2008 12:06 PM
how do i get mach to halt for a servo fault	fast89	Mach Wizards, Macros, & Addons	1	04-08-2008 02:10 AM
Will my Hurco KM-1 maintain speed with step/dir drives and Mach 3...?	DaSnake	HURCO	2	07-28-2007 05:17 AM
Is Mach 3 able to control 3 independent gecko drives?	mrmz	Mach Software (ArtSoft software)	1	07-27-2007 05:13 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)