| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-19-2009, 08:16 PM
| |||
| |||
Hi i have a table with 4 g201 .I have the 260 oz rexstep motors i dont think they even offer those any more. My question is everyone says to set the pulse to 2 but my motors just chug at 2 if i change it to 5 for both they move fine. I am running a 3 to 1 gear with a 1" pinon gantry weighs about 45 lbs i have the x slaved with a , and running 48volts . I was wondering is there something wrong with my electronics if i have to keep the pulse at 5 . not only that i can only get about 120ipm before losing steps any suggestions on the pulse would be high appreciated , i am also running the mini io breakout board. John  |
|
#2
04-21-2009, 07:38 PM
| |||
| |||
| In Mach3, ports and pins, set STEP 'active low'. Use a breakout board from either Bob Campbell Designs, CNC4PC, PMDX or C and CNC. Others may not be compatible. Mariss |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Step Pulse Multiplier | RotorRouter | Gecko Drives | 15 | 08-02-2010 01:00 PM |
| Step Pulse Sniffer | Mariss Freimanis | Gecko Drives | 40 | 12-01-2008 06:20 PM |
| G903 Step Pulse Multiplier Board? | The_Doctor | Gecko Drives | 5 | 05-05-2008 12:29 PM |
| G340 step pulse multiplier | pescado_loco | Gecko Drives | 0 | 01-12-2008 07:46 PM |
| MACH3 Maximum Step Pulse rate | Ken_Shea | Mach Software (ArtSoft software) | 4 | 09-21-2005 08:14 AM |
| | |
Linear Mode
