| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-16-2009, 11:32 PM
| |||
| |||
I can't get my keling 387oz-in motors to step evenly with my G540. I am trying to tune them with the pots on the g540 and they are set at 4000 steps per inch in mach3. I don't know where the original pot setting was set to on my g540 because it has been turned in all different directions trying to tune them. It's weird because sometimes i can get the motor to turn evenly and consistently in only one direction but as soon as i press the opposite direction it will go then stop and go then stop. Its not fluid. I need help before i blow my head off here.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Keling motors & drives | cut more | Automation Technology Products | 95 | 12-13-2011 07:47 AM |
| G540 w/387oz.in DB9 HOT! | jwillhite | General Electronics Discussion | 6 | 12-05-2008 11:55 PM |
| Anyone using keling inc stepper motors ?? | lemonyx | Stepper Motors and Drives | 12 | 04-03-2007 07:56 PM |
| torquecurves for keling motors? | gotis | Stepper Motors and Drives | 11 | 04-05-2006 07:01 PM |
| Keling Stepper Motors | andy_ck87028 | Stepper Motors and Drives | 2 | 01-23-2006 09:34 AM |
| | |
Linear Mode
