Q: Mach3 Wiring / Toggle Switch

[Deviant]

I was wondering if anyone had relocated the fault lights to the front of your case?

Or used some type of plastic/fiber to redirect the output to the front panel of your box.

-Thanks,

[CoAMarcus]

There is a circuit to hook up an external fault signal on page 5 of the G320 manual. You can find the manual here:
http://geckodrive.com/upload/G320-REV-7-Manual.pdf

Marcus

[Deviant]

Thanks for the link.

No I just need to decipher the squiggles.

[Deviant]

Ok I guess it pays to read the manual.

Assuming that Mach3 will estop based on the fault error. I don't need the external fault light.

At least not at this point.

I've attached a scanned picture of my understanding of how this should be wired.

If I'm incorrect. Feel free to bash me soundly.

Thanks for the help.