| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#13
 
05-27-2003, 03:20 PM
| ||||
| ||||
| The answer to you question depends of what software you plan to use. Most (all?) of them can be configured so that a choice of LPT pins can be used for step/direction etc. I would suggest you look at your software documentation and then choose what pins do what from there, then wire accordingly. Eric
__________________ I wish it wouldn't crash.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New and need your help Please (driver board) | Oldmanandhistoy | General Electronics Discussion | 17 | 06-12-2005 04:48 PM |
| what voltage? i'm confused.. Stepper motors + driver board from hobbycnc | Loterus | Hobbycnc (Products) | 8 | 01-26-2005 07:10 AM |
| Xylotex or Gecko step driver for my Mill/Drill? | pfeist | General Electronics Discussion | 10 | 07-20-2004 01:42 AM |
| High amp driver board | jimglass | General Electronics Discussion | 1 | 04-09-2003 08:46 PM |
| | |
Linear Mode
