Mach Profile for G320 and mini I/O board?

[richlandrick]

Is there a mach profile out there somewhere for the G320 gecko drives and the mini I/O breakout board?

If not, does this make sense?

Active low for both step and direction.

Pins
X Step 2
X Dir 3
Y Step 4
Y Dir 5
Z step 6
Z Dir 7

E-stop on the mini I/O breakout board jumpered.

Any other input would be appreciated because. The Gecko drives are controlling the motors, but not responding to the computer inputs.

[BobWarfield]

Curious to see the answer on this one. Sounds like the drives are holding the servos in position, but not listening to Mach3?

Best,

BW

[richlandrick]

I recieved help from the makers of the I/O board - CandCNC. They have a profile for their mini-I/O board posted on their Yahoo site. After properly installing the profile I was ready to go.

Funny thing though. The board was supposed to come with instructions and a CD containing the necessary profile among other things. The retailer omitted these when teh board was shipped this past July. Now the Mini-I/O board is obsolete.

I guess that just means that it has been replaced with a new and better although more expensive brake out board.

Any way, I'm off exploring my latest problem - trying to get a AMD dual core bare bones comuter with a PCI card parallel port to run Mach. The Mach driver test keeps saying "too fast."