Newbie Problem between Gecko 540 & Mach 3 - CNCzone.com-The Largest Machinist Community on the net!

rad45 · #1 12-22-2008, 05:14 AM

Hi People,
Am installing a G540 to my Mach 3 controlled 4 axis mill.
Have everything sorted out other than how to hook up the height setting function for Z axis with a touch plate. Does anyone have a suggestion on how this can be set up please?
With thanks and kind regards,
Russell,
in Perth, Western Australia.

ger21 · #2 12-22-2008, 08:07 AM

There's a great thread here by Greolt on how to do this. Sorry, but I don't have the link handy right now.

rowbare · #3 12-22-2008, 11:21 AM

Originally Posted by ger21

There's a great thread here by Greolt on how to do this. Sorry, but I don't have the link handy right now.

I think this is the one you mention:

http://www.cnczone.com/forums/showthread.php?t=36099

this one is also very interesting:

http://www.cnczone.com/forums/showthread.php?t=56079

bob

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
C11G, Gecko 203v and Mach 3...connect what where?	teamtexas	Gecko Drives	16	12-03-2009 09:53 PM
Gecko System With Mach 2.6	racear*2865	Mach Mill	5	12-04-2007 01:41 PM
Is Mach 3 able to control 3 independent gecko drives?	mrmz	Mach Software (ArtSoft software)	1	07-27-2007 05:13 PM
Mach 3 Gecko	vwdevotee	Mach Software (ArtSoft software)	3	11-12-2006 08:23 PM
mach and gecko microstepping	dertsap	Mach Mill	2	05-25-2006 06:11 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)