re;g203v red light on axis not working

[woffler]

i have one of my 203's with a red light on .I caused it i hooked up wire from anouther 201 to it and the grd was wrong .Is there a way to reset it or did i pop the fuse anyway is there a way to test that fuse and how do you do it?And also were can a guy purchase such a fuse from?

[Mariss Freimanis]

No fuse = no lit LEDs at all so the fuse is OK. Remove the motor from the drive, then power it up again. If the red LED goes out when you do that, check your motor wiring. If it stays lit, its got to come back here to be looked at (free of course).

Mariss

[woffler]

I hooked anouther spare 201 to the drive and got going it did not reset the vampire though ill send it on as soon as i can thanks for the help.sorry for the problem my bad.

[Mariss Freimanis]

Just hook-up any power supply you have to the G203V. That's all you need to check it out, just a power supply and nothing else. If the red LED goes out, the G203V is good to go; if it stays on, its got to come home to be repaired. This may save you 2 weeks in shipping time back and forth if there is nothing wrong with it.

Mariss