| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-25-2008, 06:56 PM
| ||||
| ||||
I have a torch table using a master slave X to A arrangement. I am using 203V drives. The steppers run ok & not losing steps but noisy & causes vibration. My guess is a bit of tuning may help. My question is should I unhook 1 stepper & disengage the pinion from the rack gear while tuning the other motor? Or should I try & tune them together?
__________________ If it works.....Don't fix it! Last edited by millman52; 10-25-2008 at 07:32 PM.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rutex PID Tuning Help?! | UKRobotics | Servo Drives | 2 | 12-02-2007 03:26 AM |
| Help with Tuning EMC2 | blumpie | LinuxCNC (formerly EMC2) | 5 | 11-26-2007 06:42 PM |
| Motor Tuning | Smitty911 | Gecko Drives | 6 | 10-16-2007 05:40 PM |
| appropriate servo tuning.... help? | howling60 | Servo Motors and Drives | 6 | 02-27-2006 09:48 AM |
| Motor Tuning | PEU | Mach Software (ArtSoft software) | 3 | 09-27-2005 12:48 AM |
| | |
Linear Mode
