| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-29-2008, 03:39 PM
| |||
| |||
I have a cnc4pc C11T BOB set up for 3 G320 Drives. The bob has an enable output that is inverted to what is needed by the 251. I was thinking about using an inverter IC (7404) to invert the signal to allow the 251 to be disabled when the 320's are disabled. This should work without causing any problems right? -Adam
__________________ www.adambrunette.com - Converting My Harbor Freight X2 And My Jet Jvm-830 Knee Mill, As well as many other projects.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Nubie G251 Assembly Question | rlrhett | Gecko Drives | 14 | 09-29-2008 09:13 PM |
| Newbie- G251 drive and steppr 57BYGH405 | cadcamslawek | Gecko Drives | 10 | 09-28-2008 06:53 PM |
| G251 documentation error | jimlas53 | Gecko Drives | 4 | 09-21-2008 06:52 PM |
| Need Help!- G251 I think its dead. | Adamj12b | Gecko Drives | 1 | 09-18-2008 11:31 AM |
| G251 Misaligned components? | Adamj12b | Gecko Drives | 1 | 09-16-2008 10:08 AM |
| | |
Linear Mode
