| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#25
 
09-28-2008, 11:52 AM
| ||||
| ||||
| Mariss- I'm going with a 3.3k or 3.5K resistor. 3.3K only if it needs cooling down, but it should be fine. First let me see what they have  Well yes, I know that steppers get hot which is a good thing. But I once had a stepper so unbelievably hot that you would burn your fingers instantly if touched. (That because the resistors went bad an was putting huge amounts of amps into the stepper) Thanks for sending me a Gecko with the switch on the inside! My recalled Gecko is packed up and ready to be shipped, will be shipping it tomorrow. Thanks Gecko! -Jason  |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring Breakout Board Questions | Dingo745 | Xylotex | 14 | 03-31-2008 02:47 PM |
| Wiring loom design questions | andy_ck87028 | DIY-CNC Router Table Machines | 6 | 10-15-2007 06:55 PM |
| Wiring Questions | cnc2k | General Electronics Discussion | 8 | 11-27-2004 05:45 PM |
| 4-phase motor and wiring questions | DmitryZ | General Electronics Discussion | 10 | 04-13-2004 11:14 PM |
| | |
Linear Mode
