| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#15
09-29-2008, 08:13 PM
| ||||
| ||||
 Not sure, because I'm getting 4.2 today. But I used a calculator and double checked, and somehow got 4.4 at least twice. 
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- Need help with assembly please | dpark1 | Solidworks | 2 | 07-26-2008 09:43 AM |
| Question about hole sizes on Bearing Slide Assembly | kevperro | Joes CNC Model 2006 | 2 | 04-16-2008 06:33 PM |
| DIY Nubie questions. learning as i go. | Revtech | DIY-CNC Router Table Machines | 7 | 05-29-2006 08:07 PM |
| Cnchobby Board Assembly Question | jason_ices | Hobbycnc (Products) | 0 | 06-18-2005 03:45 AM |
| Nubie needs help | SPEEDRE | General Electronics Discussion | 8 | 06-08-2005 03:28 PM |
| | |
Linear Mode
