| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#13
 
08-06-2009, 09:19 AM
| |||
| |||
Hi, I recently had the same issue with the Y axis. Replaced everything you mention, wiring, drives, encoder etc etc. After much trial and testing the fault turned out to be an very weak / open circuit inside the blue plugs on the 5v feed into the Gecko 320. I think these plugs are now black. There is a fold of mental inside the terminal. Your wire must be in good contact with this and it must be in good shape. (just my observation) Replaced the plug onto the gecko with a spare one I had from another gecko and problem solved. Its always the most basic probs that take so long to diagnose.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone in Kalamazoo or Battle Creek, MI?? | AMCjeepCJ | Mentors & Apprentice Locator | 19 | 08-17-2010 06:29 PM |
| Tuning gekko 320 for servo? | Rich05 | Gecko Drives | 1 | 06-26-2008 02:57 PM |
| New Year, New Job | metalfab | CNCzone Club House | 0 | 12-17-2005 10:17 AM |
| New Year, New Job | metalfab | CNCzone Club House | 0 | 12-16-2005 11:40 PM |
| | |
Linear Mode
