| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-02-2004, 11:17 PM
| |||
| |||
I'm trying to trouble shoot the 320 Geckos that came with my mill. I'm new at this so could anyone explain where do I get a step and direction pulse source to perform the setup? I have encoders on my servos. Sorry for the newbie question. Paul    |
|
#2
09-03-2004, 08:19 AM
| |||
| |||
| If you have everything hooked up, then you can make a test g-code file to tune the geckos. Someting like G00 X10.0 G00 X0.0 G00 X10.0 G00 X0.0 And repeat for a good couple of miniutes run. Of course, I may have the wrong end of the stick ?!
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A Axis and Step and Direction Spindle Setup | mklb | Mach Software (ArtSoft software) | 6 | 11-27-2009 08:19 AM |
| Open Source CNC Controller Specification | gregmary | DIY-CNC Router Table Machines | 28 | 12-04-2005 10:58 PM |
| Dirction / Step lines! | bigal | TurboCNC | 2 | 02-06-2005 02:51 PM |
| Step and direction software | bgolash | Gecko Drives | 2 | 12-04-2004 01:29 AM |
| step in what direction | craftech | Stepper Motors and Drives | 5 | 10-13-2004 06:45 AM |
| | |
Linear Mode
