| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#37
 
05-29-2008, 04:48 PM
| ||||
| ||||
| Speedre, I was just looking at your BOB manual again. There is a board enable (EN) over near where the 5v logic supply for the board comes in. It needs to be at 5V for the board to work. Have you checked the voltage on it? Alan
__________________ http://www.alansmachineworks.com  |
|
#38
05-30-2008, 07:56 AM
| |||
| |||
| I plan on doing this one more time this weekend, I am going to check. and re-check, and re-test every single connection I make. I am obsessed now. if this doesnt get me smooth movement I QUIT!!!!!!!!! |
|
#39
05-30-2008, 12:04 PM
| ||||
| ||||
| If you CALL Gecko, they might help you troubleshoot it. They are three hours behind you in time, so an evening call would be possible. CR. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gecko / servo / encoder wiring | shnitzel | Gecko Drives | 2 | 07-18-2007 06:02 PM |
| Gecko wiring question | LEWENZ | Gecko Drives | 2 | 12-23-2006 08:48 AM |
| My Gecko Wiring Diagram for 201, 210, 212 Drives | CJL5585 | Gecko Drives | 27 | 11-22-2006 01:17 PM |
| wiring steppers/ gecko 201 | littlebear | General CNC (Mill and Lathe) Control Software (NC) | 0 | 10-08-2006 10:26 AM |
| Wiring an 8 lead stepper to a Gecko 201 | ChrisJ | Gecko Drives | 15 | 05-02-2005 02:15 PM |
| | |
Linear Mode
