G210 usage - CNCzone.com-The Largest Machinist Community on the net!

bubbax1 · #1 05-18-2008, 04:35 PM

Hi Folks,

I have a stepper motor that is rated for 8.1 amps.

Would I get ok performance using the G210.

Thanks,
Bubba

ger21 · #2 05-18-2008, 05:23 PM

You'll get about 86% of the rated holding torque running a Gecko at 7 amps.

bubbax1 · #3 05-18-2008, 05:26 PM

Thanks Gerry,

So it will not possibly cause damage to the drive?

Thanks,
Joe

Mariss Freimanis · #4 05-18-2008, 05:56 PM

No. The drive will limit its output to 7A.

Mariss

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)