| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-14-2008, 12:26 AM
| |||
| |||
I was using TurboCNC on a lathe and was having problems with the interface. I connected direct via the parallel cable. As advised by Gecko drive, I installed a Breakout board from Campbell designs. I changed the output pins on the port as required. On the breakout board, I changed the Jp3 connector to N1 and I checked all power levels as in the instructions. All levels are as described. I now get intermittent movement in one direction of each axis. I am probably doing something simple wrong. Any ideas?
__________________ Angelo Castellano Sunward Aerospace Group Limited www.sunward1.com    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what USB Breakout Board to by ?? | dbss | General Electronics Discussion | 5 | 01-19-2008 08:54 AM |
| Breakout board, Relays on board? | Cooper | Open Source Controller Boards | 11 | 06-09-2007 08:55 PM |
| New breakout board | corydoras | General Electronics Discussion | 6 | 04-25-2007 07:23 PM |
| New Port Interface (Breakout) Card | Torchhead | Product Announcements & Manufacturer News | 4 | 10-27-2006 04:59 PM |
| Breakout Board | ckirchen | Product Announcements & Manufacturer News | 11 | 06-20-2005 12:52 PM |
| | |
Linear Mode
