CandCNC MTA100 board to G203vs - CNCzone.com-The Largest Machinist Community on the net!

LazyMan · #1 04-11-2008, 06:31 PM

Hi, perhaps a dumb question but,

I bought the mini Combo deal and having trouble hooking up the MTA100REV2 board to my G203v drivers. In the manual it says to use GND Common for 203s but there are only 2 pins available. I managed to get two of the drivers working but I dont know how to hook up the third one because there arent any more pins available. All the other pins are commons.

Thanks in adnvance!

LazyMan · #2 04-13-2008, 11:12 PM

Alright, well. Ive that sorted out now.

Monte · #3 04-14-2008, 07:01 AM

Originally Posted by LazyMan

Alright, well. Ive that sorted out now.

Curious, what'd you do? I took a look at the manual and I think I see what you're talking about, J23.

Monte

acondit · #4 04-14-2008, 09:38 AM

Monte,

I would put two wires in one hole.

Alan

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CNC router steppers & power supply recommendations for GREX100 with 3 Gecko G203Vs	Menatep	DIY-CNC Router Table Machines	3	04-26-2007 11:15 PM
203v and candcnc bob?	ged	General Electronics Discussion	1	02-18-2007 12:08 AM
CandCNC with Limit Switches	Buzz9075	DIY-CNC Router Table Machines	3	02-03-2007 01:01 PM
CandCnc controller M03, M04 and M05	Buzz9075	DIY-CNC Router Table Machines	4	02-03-2007 07:58 AM
candcnc package or other??	2fst4u	CNC Plasma and Waterjet Machines	13	11-27-2006 01:55 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)