Gain, Damping, Limit - CNCzone.com-The Largest Machinist Community on the net!

THend · #1 04-10-2008, 02:38 PM

Greetings, the directions say to turn these parameters to quarter turn etc..

Which direction is 0% and which is 100% From what orientation as well.

??

CoAMarcus · #2 04-10-2008, 03:17 PM

When you are looking at the trimpots, turning it counter clockwise will turn it down and vice versa. On the LIMIT, for example, full CW will increase the limit to the maximum.

-Marcus Freimanis

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Filling steel tube with cement for damping/mass?	stag53	Mechanical Calculations/Engineering Design	6	11-26-2007 01:39 PM
Vibration Damping	Geof	Mechanical Calculations/Engineering Design	3	11-08-2007 02:44 PM
Loading Limit	martindugdale	CNC Machining Centers	0	05-08-2007 07:06 AM
in posistion limit??	miljnor	Haas Mills	4	03-16-2005 12:09 AM
Limit switches...what do I need?	bgolash	DIY-CNC Router Table Machines	1	03-09-2005 08:23 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)