retrofitting cncmasters Jr. mill

[gv71]

I am retrofitting this for a college for what ever reason the old control didn't work and bought another control and plugged it in and that would only move in increments. There were phone calls made but nobody got back, poor customer service, so sent the control back and the O.K. was given by the college to retrofit another control. I'm not sure which stepper drives to get and I need 4 as the 4th axis is on this one. The xyz stepper motors are Eastern Air Devices 3.1v 2ph 5.0a LA34CKK-2J, the 4th axis is Slo-Syn BM101025 M063-LS09 2.25v 4.6a. I would also need a power supply and I know there is alot of software out there just wondering which works best with these drives if there is any difference. Here is the link to there website http://www.cncmasters.com/CNC%20Jr%20Mill.htm
The machine that is to be retrofitted is an older one without the handles and has belts on the x and y axis. I would like to keep the same resolution and feedrate if possible.

Thanks, Greg

[Dan Mauch]

You might want to take a look at my web site at www.seanet.com/~dmauch and look in the product section. I can supply a 4 axis stepper motor drivers with a 36V 25A power supply,cooling fan, heatsink, assembled and test4ed with cable.
Many people on this list will tell you of my exceptional customer service.
Dan
Camtronics Inc

[HomeCNC]

Yes, I'm sure the Gecko stepper drives would work for this just fine.