| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-30-2008, 06:21 PM
| |||
| |||
Hi All, I've run into a deal on an unused 4x8 Chinese router table and a controller. The controller is a Camtronics box with a main power supply and three G201's. The former owner never got the unit fully assembled. It looks like the controller requires a 5V input thru a port on the back. What is the best way to add a 5V power supply?  |
|
#2
03-30-2008, 09:08 PM
| |||
| |||
| Get it from your PC; a USB port cable is the most convenient way. Mariss |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using Delrin for Bearing Housing? | SPEEDRE | Mechanical Calculations/Engineering Design | 5 | 01-18-2008 09:10 PM |
| g201's motors buzz, but do not move | mxpro32 | Gecko Drives | 9 | 09-06-2007 05:25 PM |
| powder coating a spindle housing? | DennisCNC | Mechanical Calculations/Engineering Design | 4 | 01-16-2007 10:08 AM |
| Where to purchase g201's? | mdoan | Gecko Drives | 2 | 10-27-2004 01:59 PM |
| | |
Linear Mode
