G340 step pulse multiplier - CNCzone.com-The Largest Machinist Community on the net!

01-12-2008, 07:46 PM

pescado_loco pescado_loco is offline

Join Date: Jan 2005

Location: USA

Posts: 37

G340 step pulse multiplier

permalink

This is my first servo motor project & I have no clue where to set the step pulse multiplier on the G340. I'm running 850 oz/in servo motors with HEDS 500 line encoders. What are the pros & cons of setting the multiplier low (1) or high (10).

All help will be appreciated.

Happyness is a state of mind

Last edited by pescado_loco; 01-12-2008 at 09:39 PM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Step Pulse Multiplier	RotorRouter	Gecko Drives	15	08-02-2010 01:00 PM
G903 Step Pulse Multiplier Board?	The_Doctor	Gecko Drives	5	05-05-2008 12:29 PM
pulse multiplier	Beyazbalina	Stepper Motors and Drives	0	03-25-2007 04:37 AM
Am I going to need a pulse multiplier for this setup?	WoodSnarfer	Gecko Drives	1	02-16-2005 09:19 PM
G340 multiplier	gbon2	Gecko Drives	7	12-15-2004 09:26 AM

All times are GMT -5. The time now is 05:46 PM.