| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-09-2008, 11:58 PM
| ||||
| ||||
I have 2 gecko G320's and mine say "Common" next to step/direction. 1. Why do some diagrams say +5vdc instead? 2. I have a C11 Bob from cnc4pc, Can I run that to "com" pin located next to Xstep and Xdir or should I move my Jumpers so that "Com" becomes +5Vdc? Help is much appreciated  Last edited by beezerlm; 01-12-2008 at 06:47 AM.  |
|
#4
01-12-2008, 04:00 PM
| ||||
| ||||
Figured it out on my own.  The geckos need +5Vdc at the terminal labled common. I switched jumpers on the c11 BOB so that "com" was +5Vdc. I wonder why my gecko says "common" and not "+5Vdc"? Motors are movin = FEELGOOD!  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "low end" HF Spindle or "high end" router for about $1000? | biomed_eng | DIY-CNC Router Table Machines | 14 | 01-06-2012 12:15 AM |
| BattleAxe "aka" Ball and Chain "aka" the wife. | ZipSnipe | CNCzone Club House | 48 | 05-18-2008 09:53 AM |
| Has anyone looked at the "JET" or "Shop Fox" manual machines? | boosted | General Metal Working Machines | 12 | 03-04-2007 09:33 PM |
| Vertical system "jerks" and "bangs"?? | REVCAM_Bob | Servo Motors and Drives | 5 | 06-12-2006 09:09 AM |
| Add "View New Posts" to "Main Menu" | Mr.Chips | Forum Questions or Problems | 4 | 04-21-2004 10:54 PM |
| | |
G320 "common" or "+5vdc" why do they vary? 
Linear Mode
