| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-30-2007, 08:16 PM
| ||||
| ||||
I am running a few kelling steppers 3 201A's and a candcnc breakout board. I am getting my 5v from the board, the motors lock up, but don't move when I jog. The wierd thing is i can get a motor to spin if i twist the shaft with my finger a few rotations. It will spin on it's own like this until i push the jog button. Bottom line is i need some help big time. I don't THINK they are blown, i know this because I used to have 4 geckos, one doesn't light up anymore.
__________________ When all is said and done, more is said than done.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| new guy with old problems | xxxlmark | Bridgeport and Hardinge Mills | 0 | 08-08-2007 12:41 PM |
| Tsc problems | Rawr77 | Haas Mills | 5 | 02-23-2007 11:42 AM |
| problems? | steveo | Mastercam | 5 | 08-17-2006 12:59 PM |
| Run from here problems? | CNCadmin | Mach Mill | 5 | 11-30-2005 09:38 PM |
| | |
Linear Mode
