| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-22-2007, 09:03 PM
| |||
| |||
Hi, The Z servo for my IH mill servodrive is giving a fault light, and z axis is not operating. For a while the Z axis was on occasion not working. Now the fault light is on. It seemed the problem started when i was looking for the lose connection and disconected a wire that went from ERR/RES to Enc+ i think. The mill became erractic when that happened. However I dont really know anything about this stuff. I tried disconnecting the red and black that goes to servo motor to see if the motor was shorting or something but the fault light does not go out. I tried disconecting all the inputs etc except the power to ground and dc + and still the fault light is on. My knowledge of electrical engineering is highly limited. any help appreciated! thanks R.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gecko Fault Circuit | bgolash | Gecko Drives | 3 | 10-01-2006 09:51 PM |
| Help with selector switch wiring issue (***actually a motor issue***) | BEDFORD | Industrial Hobbies (Support forum) | 7 | 04-07-2006 03:19 PM |
| THC Issue | Aldoseri | CamSoft Products | 3 | 01-31-2006 04:33 AM |
| Help! Consistent Gecko Fault or Servo Stall | Noah | Gecko Drives | 11 | 06-30-2004 10:48 AM |
| To Gecko, or not to Gecko...that is the question! | samualt | Gecko Drives | 11 | 09-22-2003 08:42 PM |
| | |
Linear Mode
