bridgeport boss 8

[AdamD]

Please help I posted at the yahoo group didn't get a reply I have searched this and other fourms. Couldnt find a complete answer to my ?. I just bought a boss 8 mill. What drive do i need 320 340? What can Iexpect for ipm with gecko, is the limiting factor the parallel port orthe drives? Do I want to go with grex 100? I am using mach3 on 2gig512ram computer. I know I will need to reduce my voltage for the geckodrives can i us a varica to limit primary voltage to the transformer? I think I need to add an encoder tomy factory servos.
Thank you for your help

[silverstreak]

AdamD,
I just ran across your post looking to answer some factory servo drive wiring questions. I have a Bridgeport R2E3 BOSS 8 that I am upgrading with a Camsoft Professional package. I have a set of factory wiring schematics but am unable to identify the servo drive motion command signal wires and the servo drive enable wires. I do believe the signal comes from a processing board (FMDC, DLI, ect.) but ??? I imagine that if you used the existing servo motors you have identified these wires. Any advice would probably help.
Thanks,
Dan

[Neal.R2E3]

is their any way i can get a copy of those wiring scematics