201A blown? - CNCzone.com-The Largest Machinist Community on the net!

09-27-2007, 07:43 AM

BalchSigns BalchSigns is offline

Join Date: Mar 2006

Location: USA

Posts: 4

201A blown?

permalink

I have a cnc router with Flashcut and gecko drives. Last week my wife decided to move the gantry down the length of the router without turning on the system. Now the flashcut signal generator gives up and disconnects when ever I try to run the router.

I moved the flashcut sg over to another router and it works fine. So I am thinking that the Gecko 201 is blown by the stepper motors being spun. It just occured to me that I didn't check the supply voltages on the switching supply. So that might be a problem.

Any opinions?

ernie

www.balchsigns.com

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
You will be blown away!	CNCadmin	Forum Questions or Problems	17	10-15-2006 07:09 AM
Blown Fuses	sommerjd	General Electronics Discussion	6	10-01-2006 04:02 AM
driver chip blown it	Com	Hobbycnc (Products)	12	07-21-2005 02:46 PM
power supply for 201a	asitech	Gecko Drives	2	02-12-2005 02:03 PM
power supply for 201a	asitech	General Electronics Discussion	8	01-31-2005 11:12 AM

All times are GMT -5. The time now is 05:43 PM.