| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-14-2007, 06:10 PM
| |||
| |||
Hello, I just set up my first bench mill and the A and Z work fine. Y works perfectly going negative but if I try positive it will jerk forward half an inch and stop. If I hold down the jog it will jerk forward a few times then take off. When the Y takes off I can still stop it by hitting the Y jog button in either direction. I've tried adjusting the gain and damp but get the best result around the 10:00 position. Any advice would be appreciated. Shepard  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Starter Projects for a Novice? | Minesgeek | General Metalwork Discussion | 5 | 01-16-2007 12:14 AM |
| Novice to CNC | mattinker | Mechanical Calculations/Engineering Design | 0 | 11-27-2006 01:27 PM |
| Novice Tutorials, schematics | johnnydoughey | Servo Motors and Drives | 2 | 11-22-2006 03:13 PM |
| Good reference for novice machinist? | jharmon | General Metalwork Discussion | 1 | 11-14-2005 11:11 PM |
| Small CNC engraver - novice questions | workaholic_ro | Benchtop Machines | 1 | 11-14-2005 04:13 PM |
| | |
Linear Mode
