| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-20-2006, 12:53 AM
| |||
| |||
I have g-rex 100 and heard mach3 has homes working now, could x axis share a switch for home and limit?and which terminals would I use?I also would like to know does g100 need usb hooked up to run mach3 or just for firmware etc, thanks shawn  |
|
#2
07-20-2006, 05:17 AM
| ||||
| ||||
| They should be able to share a switch, and any input on the g100 should work. Mach 3 doesn't use the G100's USB, just ethernet.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
