| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-13-2006, 12:57 AM
| |||
| |||
I know this will have been asked before but I can't seem to find it. Can two steppers be run on one 201 so long as the voltage and amps stay within limits? I guess it's obvious to most that what I'm on about. Can I run a smaller stepper on each side of the gantry electricaly linked?  Thanks, Greolt  |
|
#2
06-13-2006, 06:25 AM
| ||||
| ||||
| Mariss from Gecko has said before that you can at slower speeds. If the motors are smal enough, just get a 4 axis HobbyCNC and give each motor it's own drive.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
