Gecko's limited to only 20A ?

[turmite]

Hey guys thanks for all the comments and help. I just got a pm from a fellow wha has been watching this thread because he has the same carving speed needs as I do. He thanked me for asking questions that he needed answers to. That is what I like about this forum. You never really know how many people are reading and learning and never let you know they are there. If I have made very many typos here I left my glassed at the shop and I can't really read what I have typed.

No one has yet addressed the question I posed about using one power supply for three servos and one stepper. Should I look at that or do I need seperate power supp;ys.

Turmite

[balsaman]

It depends on the drivers. If you use gecko 320's for the servos and a 210 for the stepper, you can go with up to 80 volt supply for both. Other stepper drives are limited to 30 volts, so you would probably need two power supplies.

Eric

[turmite]

Thanks Balsaman. I will go and reside at the Gecko site for a while since I kinda know what I need.