| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-19-2012, 05:13 PM
| |||
| |||
I was dialing in a G540 last night, and the "sweet spot" or spot where the motors ran the quietest was right up against the stop on the trim pot. All three steppers connected were the same. Any comments?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WHO has a sweet Z axis? | breathe | Open Source CNC Machine Designs | 0 | 10-11-2010 02:35 PM |
| need help for g540 motor tuning. | Technogod | DIY-CNC Router Table Machines | 2 | 11-06-2009 10:47 PM |
| sweet | jrj5x5 | Camaster | 0 | 11-06-2008 12:15 AM |
| Off topic but sweet | cadfish | CNCzone Club House | 1 | 05-12-2006 02:49 AM |
| Got a sweet ballscrew | Zumba | CNCzone Club House | 1 | 04-07-2006 06:22 PM |
| | |
Linear Mode
