| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-26-2005, 11:12 AM
| |||
| |||
 The motors are fine encoders are ok but i have three G320's that wont reset. When i pull them high with 5v for five seconds they wont engage. Are they dead? or cant they be reset. I think the got nailed with 24 volts my employee was doinig some wire clean up while the system was hot and I saw a little smoke coming from the Breakout board. And it killed the parallel card.any suggestions?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
