| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-01-2011, 02:09 PM
| |||
| |||
I recently bought a g540 and I read on the manual that it is set to 10 microstep. Does that mean that it canīt run my stepper motors which is available to: full - half - quarter and eight step modes?  |
|
#2
10-01-2011, 03:34 PM
| ||||
| ||||
| It'll run any stepper motors, but only at 1/10 microsteps.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quick G540 question | SatanKlawz | DIY-CNC Router Table Machines | 10 | 07-20-2011 02:41 PM |
| Need Help!- X2 G540 Wiring Question | Steoh | Benchtop Machines | 6 | 03-01-2011 06:53 PM |
| Need Help!- Question on Gecko G540 | blackonblack | Gecko Drives | 9 | 05-29-2010 09:54 PM |
| G540 e-stop question | vintageracer | Gecko Drives | 3 | 01-04-2010 04:45 PM |
| g540 question | chrisw765 | Gecko Drives | 2 | 04-09-2009 10:35 AM |
| | |
Linear Mode
