| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-26-2011, 02:32 PM
| ||||
| ||||
Okay, I can move all motors, charge pump works fine, estop works correctly, etc. Now I am trying to setup physical limit switches and the problem is that limits are not detected. when my (hall sensor + magnet) limit switch is tripped, the input gets grounded, however nothing is displayed within the MACH screen. Any suggestions?  |
|
#3
10-01-2011, 09:39 PM
| |||
| |||
| The devil is always in the details.:-) Mariss |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ok.... I like the Gecko G540, but... | Bob La Londe | SmoothStepper USB Motion Control | 1 | 06-01-2011 05:55 PM |
| Gecko G540 ?? | gitarre10000 | DIY-CNC Router Table Machines | 18 | 11-23-2010 09:55 PM |
| Newbie- Gecko G540 | Deb.bosch | Stepper Motors and Drives | 1 | 03-19-2010 08:40 PM |
| gecko g540 | Teyber12 | Benchtop Machines | 3 | 05-31-2009 02:23 PM |
| G540 Low voltage for E-stop and limits? | MrWild | Gecko Drives | 4 | 10-14-2008 04:28 AM |
| | |
Gecko G540 not detecting limits 
Linear Mode
