| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-23-2011, 11:29 PM
| ||||
| ||||
x2, G540 and Mach3 missing steps on my Y axis, swapped cables with the X and the miss followed, the DRO in Mach will count up/down but the stepper wil not move, it seems to run fine until I power up the spindle. I have it wired up so Mach can control the spindle but am only using the manual switch for now, the problem didn't show up until I tried to set up a 4th axis, when I switched everything back it started missing. Hood looked at my XML and said it looked ok, I wonder if I might have ground problem, any ideas???  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- weird cutting (Missed steps?????) | MonoNeuron | DIY-CNC Router Table Machines | 4 | 01-11-2009 06:03 AM |
| Ground Loops and Missed Steps | cbcnc | General Electronics Discussion | 34 | 03-16-2008 02:34 PM |
| Missed steps and back EMF question | wjfiles | General CNC (Mill and Lathe) Control Software (NC) | 3 | 08-14-2006 08:11 AM |
| Missed Steps | fool | Machines running Mach Software | 11 | 04-04-2006 06:51 PM |
| Problem with error or missed steps or something? | rustyolddo | TurboCNC | 18 | 07-10-2005 08:51 AM |
| | |
Linear Mode
