Results 1 to 1 of 1

Thread: G540 Relay Wiring - Quick Question

  1. 12-06-2010, 04:37 PM #1
    strohkirchw
    strohkirchw is offline
    Registered
    Join Date
    Oct 2010
    Location
    usa
    Posts
    132
    Downloads
    0
    Uploads
    0

    G540 Relay Wiring - Quick Question

    Just wanted to verify for a 48vdc relay for spindle/pump control on the g540 and since I'm new to the relay stuff.

    Coil - +48vdc and -48vdc
    C - HOT
    NC - Whatever
    NO - HOT
    Last edited by strohkirchw; 12-07-2010 at 03:22 PM.

« G203V Opto Polarity - Why? | Losing Steps with G212 »

Similar Threads

  1. Quick question regarding G540 box...
    By stombory in forum Gecko Drives
    Replies: 7
    Last Post: 11-02-2009, 04:59 PM
  2. Wiring diagram for Gecko g540 and cnc4pc C8 relay
    By blackrat in forum Gecko Drives
    Replies: 2
    Last Post: 04-25-2009, 06:22 AM
  3. embarassing relay wiring question
    By endgrainguy in forum General Electronics Discussion
    Replies: 5
    Last Post: 01-14-2009, 08:40 PM
  4. Quick Starter Relay Question for regular motor
    By Cartierusm in forum General Electronics Discussion
    Replies: 4
    Last Post: 01-13-2009, 01:38 PM
  5. Gecko G540 Quick question
    By mad_dog096 in forum DIY CNC Router Table Machines
    Replies: 0
    Last Post: 01-02-2009, 10:06 PM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.