| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-18-2010, 09:26 AM
| |||
| |||
I have a Bob Cambell control it is 3years old and has work very well until know The y axis Gecko drive 203v is not working it stoped will cutting the 2 wires from the A phase and B phase terminals have been hot and they melted to gether at the terminal block. I have switch the motor and cable to another axis and they work fine. is it possible that the drive its self just failed and i just need to replace it.butchw5@yahoo.com  |
|
#2
11-18-2010, 09:30 AM
| |||
| |||
|
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Will 203V Gecko drive control a Boss 3 stepper motor | jbrant | Bridgeport and Hardinge Mills | 9 | 12-18-2010 06:55 PM |
| Need Help!- WTF C11G Gecko 203V | georgeburns | DIY-CNC Router Table Machines | 17 | 06-05-2008 10:57 AM |
| pac-sci and gecko 203v | JKuhn | Gecko Drives | 0 | 10-06-2007 11:42 PM |
| gecko 203v question | skankpile | Gecko Drives | 2 | 09-25-2007 04:41 PM |
| Gecko 201, 202, 203V vs WS-2H090M | Goose80 | Gecko Drives | 2 | 01-20-2007 01:14 PM |
| | |
Linear Mode
