| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-14-2010, 03:14 PM
| ||||
| ||||
What voltage should I see on the output pins? I'm suppling 24vdc. When emc2 toggles the output pin, I see it swing from 0v to .245v on my Fluke. Should I see the full 24v or just 5v ? My power light isn't working, and maybe more. Sigh.
__________________ TIA, Rick  |
|
#2
09-14-2010, 03:32 PM
| ||||
| ||||
| Which output pins are you referring to? The outputs on G540 are at ground potential when active. If you look at the schematic on page 6 here: http://www.geckodrive.com/upload/G54...4%20MANUAL.pdf you'll see one side of the relays connect to the power supply and the other to the G540. When the pin goes active it's like closing a switch to ground.
__________________ Bob "Bad decisions make good stories." |
|
#3
09-14-2010, 04:10 PM
| ||||
| ||||
| Ok, I get it. The G540 is toggling the ground side instead of supplying the power to the relay coil. Thanks.
__________________ TIA, Rick |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| G540 VFD Output with KBIC? | vlmarshall | Gecko Drives | 4 | 03-20-2010 07:44 PM |
| Need Help!- motor output voltage? | christ371 | General Electronics Discussion | 4 | 12-09-2009 06:42 PM |
| G540 Spindle speed output voltage problem | georgef8 | Gecko Drives | 5 | 09-22-2009 10:18 AM |
| G540 Output Help | finishlinewrx | Gecko Drives | 5 | 07-10-2009 12:39 PM |
| Is this Input or output voltage | Mr.Chips | Xylotex | 8 | 01-24-2007 09:36 AM |
| | |
Linear Mode
