| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-23-2010, 12:59 AM
| ||||
| ||||
Recently got my G203V and these are tiny and beautiful.. I have wired all the connection but i am perplexed about the TERMINAL10 on which it is written COMMON!!! What does the COMMON means?.. Your reply in this regards is highly appreciable?
__________________ http://free3dscans.blogspot.com/ http://my-woodcarving.blogspot.com/ http://my-diysolarwind.blogspot.com/ Last edited by Khalid; 08-23-2010 at 06:01 AM.  |
|
#3
08-23-2010, 06:16 AM
| |||
| |||
| Hi Khalid, Good to know that you are safe from all the flooding in your part of the world. Common is usually plus or minus 5vdc. In the case of the G203V you want the ground connection that comes in on your PC printer port. I believe that would be the gnd connection shown next to pin # 15 on your diagram. Cheers Buddy!
__________________ "Error of Opinion may be tolerated where Reason is left free to combat it." - Thomas Jefferson |
|
#4
08-23-2010, 07:03 AM
| ||||
| ||||
| Thanks jhowelb  We are safe here.. A narrow escape from flood about 3Km distance ... Thanks for helping me... Pin 18 upto 25 at Parallel Port are COMMON.. So the Ground going to all the circuitary ended to PIN22 of parallel Board... Thanks for your help . Regards
__________________ http://free3dscans.blogspot.com/ http://my-woodcarving.blogspot.com/ http://my-diysolarwind.blogspot.com/ |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to wire G203v disable connection with BB Estop circuit | Dale gribble | Gecko Drives | 3 | 12-21-2009 06:56 AM |
| G203V help !!!!!!! | native34 | Gecko Drives | 6 | 09-15-2009 12:23 PM |
| G203V | BOBINETTE | Gecko Drives | 1 | 08-09-2009 10:08 PM |
| g203v help | eloid | DIY-CNC Router Table Machines | 1 | 08-18-2008 07:59 PM |
| G203V and resonance | stevespo | Gecko Drives | 5 | 09-09-2007 10:20 PM |
| | |
Linear Mode
