03-23-2010, 01:08 AM
|
| | | Join Date: Dec 2005 Location: usa
Posts: 124
| |
Wiring help eBay BoB and G251 controllers | |
Well it's time to replace the Xylotex.
New machine, new controller.
I purchased this BoB from eBay and some G251s.
I have read through the forums about wiring the 251's but I dont have the same BoB. Before I turn a year of waiting and new drives into blue smoke I wanted to see if I could get some help on where to install the signal GND on my BoB. Also to make sure I have everything planned out right before flipping the switch. Bob Manual
My motors are 4 wire bipolar, so please over look the wires in the drawing for this question.
But my motors state....
The steppers are wired as follows:
RED-B# BLUE-B BLACK-A# GREEN-A
So does A# = /A? and so on with the B's?
Thanks,
Eric
__________________
Theres a good side to every bad side, you just have to look around the corner.
Last edited by dbtoutfit; 03-23-2010 at 01:23 AM.
|
Similar Threads 
Linear Mode
