Gecko panel wired


Results 1 to 2 of 2

Thread: Gecko panel wired

  1. #1
    Registered
    Join Date
    Mar 2003
    Location
    USA
    Posts
    104
    Downloads
    0
    Uploads
    0

    Default Gecko panel wired

    Hi,

    Just a little show and tell. I'm almost ready to make chips and discovered I need a different printer cable. Need pins at both ends. The steppers lock when powered up so that is a good sign. No smoke either.

    I'm using the Axxus control board and three Gecko boards to drive 550 oz/in steppers. Probably make chips tomorrow night.

    I built this with knowledge obtained right here. Thanks for all the pointers. A Servo project will be next.

    Jim

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Gecko panel wired-electric-panel-jpg  


  2. #2
    Registered balsaman's Avatar
    Join Date
    Mar 2003
    Location
    Canada
    Posts
    2139
    Downloads
    0
    Uploads
    0

    Default

    Nice, should have lots of power!

    Eric

    I wish it wouldn't crash.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Gecko panel wired

Gecko panel wired