Hi Guys,

As the Title implies, I have a Gecko G540 & Mach3 Combination which has been running fine but occasionally throws up an 'Active Limit Switch' Error.
My Machine has neither E-Stop nor Limit Switches fitted to it, and the Charge-Pump on the Gecko Drive is turned off.
The Machine has been running perfectly for well over three Years, but has been sitting idle for six Months, and is now throwing up this error.
I've checked all my Wiring and have not found any obvious fault, and I'm at a loss for an explanation.
Can anyone assist with a few ideas please.

MMcK.

Similar Threads: