- Need Help!- Gecko 251x calibration and setup.
-
Registered
Gecko 251x calibration and setup.
I built a open builds Ox and have wired up four g251x's for my motors. I've look online but am still not sure what I need to put in the Linux CNc software about what level of micro stepping this driver supports. No matter what I try I keep getting movements to small or large for the distance I'm trying to move. What microsteping does the g251x support and how do I put that in to the Linux cnc step configure wizard.
Secondly can any one get a recording of what pitch I'm looking for when adjusting the microsteping potentiometer on the g251x?
Thanks you all. Ps I'm a newbie.
Similar Threads:
-
- Need Help!- Gecko 251x calibration and setup.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules