| |
|
#25
 
07-30-2008, 05:15 PM
| |||
| |||
| Hello I do not know where to begin. Do not know at what Stepper motor Voltage to run. How much VA rating ring transformer to use. How many Amp transformer to use. How many transformers, each axis or one large transformer. Do i need optocouplers between stepper driver and G-Rex G100 How to wire the Home sensors Spindle control etc. All with MACH I would be very grateful to hear from anyone willing to help with a wiring diagram. I can email all .pdf to components etc Stepper motors: Nema23 1.8 BIPOLAR ONLY PARALLEL Current 4.2 A/Phase Resistance 0.7 +/-10% ohm/Phase Inductance 3.2 +/-20% mH/Phase Holding torque 300 N.cm Min Stepper Driver Card: CW250AC Home switches: Omron TL-Q5MC1-Z Variable speed drive: VFD015M Delta inverter 220v 1.5kw Many thanks Carl  |
| Sponsored Links |
| |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring help..... | fineartlig | Industrial Hobbies (Support forum) | 1 | 09-24-2007 11:21 AM |
| Wiring help | watsonstudios | Automation Technology Products | 4 | 06-12-2007 11:32 PM |
| need help wiring | dtman | CNC Plasma and Waterjet Machines | 11 | 02-19-2007 07:55 AM |
| wiring it all together | russell | General Electronics Discussion | 2 | 08-22-2006 09:08 AM |
| P5 Wiring | tintruder | Servo Drives | 2 | 02-03-2006 11:13 AM |
| | |
Linear Mode
