| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| G-Code Programing Discuss G-code programing and problems here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
12-20-2009, 07:05 PM
| ||||
| ||||
| A G71 Type I finish profile must have monotonous increases in X-axis. G71 Type II allows up to 4 valleys (in X) within the finish profile. In both cases Z must be monotonous. G71 Type I is designated by a single axis move in the P block: G71 P101 Q101 G00 X1.5 G71 Type II is designated by a 2 axis move in the P block. G71 P101 Q102 G00 X1.5 Z0.1  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CNC programming - HELP | kyo_ysh | General Metalwork Discussion | 3 | 01-11-2010 09:42 PM |
| Need Help!- programming | rajanvadakkepat | Fanuc | 6 | 10-10-2009 09:22 AM |
| need programming help | Joe Miranda | Milltronics | 1 | 10-04-2008 07:08 PM |
| Problem- PLC PROGRAMMING | jp41558 | General Electronics Discussion | 5 | 07-31-2008 01:17 PM |
| Programming two ops | chuy | Mastercam | 2 | 06-10-2007 11:01 PM |
| | |
Linear Mode
